This item is made to order and has a 1 to 2 week lead time from the date you place your order.
No refunds or cancellations will be given once the order is placed. Please be aware of the lead time, expedited shipping will not change the lead time.
Control box comes pre-wired and tested. All you need to do is mount the box, run your power wire into the box and run the heater wires and other accessory wires out.
a digital 1/16 din pid controller
3 magnetic contact relays rated to 40 amps each. (this is enough to run 6-3200 watt heaters at 220v) much safer and reliable than SSR's. When these contactors fail they fail "safe" when a SSR fails it usually takes out all components
includes switches for light, fan, and also manual control of heaters
includes high amp distribution block for connecting your power source. This block is rated for 115 amps and has lugs for up to #2 wire. Blocks are UL listed and approved.
uses 220-240v 4 wire for operation, heating system is wired for 220-240v and controls and accessories are wired for 120v
includes 6" k-type thermocouple, this probe has a 6ft high temp wire attached to it
all of these components are prewired in a gray UL listed steel enclosure. This box has punch outs on every side for you to run your wires into it.
Does not include:
fittings to put conduit into the box
power cord to run out of the box